December 2014 - Engines & Parts For Sale

All Classified Ads

1 cylinder flywheel engine with 34-3/4” flywheels and Webster Tri-polar, last ran about 4 years ago, comes with 31” diameter buzz saw, engine is not on a cart. (ed note: seller does not know the manufacturer of the engine or the hp but I think it probably is a 7hp Economy/Hercules), $1000; JE Stray nnn-nnn-nnnn (Centralia WA)

Associated 2 hp hopper cooled engine, good compression, reconditioned mag. No cart, $950. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Cushman Cub, EK mag, runs, on homemade cart, $350. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Economy 1-1/2 hp one cylinder, early 1900’s era, with Webster tri-polar oscillator magneto igniter. Has flat belt drive pulley, in excellent condition, $700; Terry Foutch nnn-nnn-nnnn (Port Orchard WA)

Fairbanks 4 hp, on iron-wheeled wagon. Missing trip arm, otherwise complete. Embossed script 'Fairbanks' on water hopper. Photos available, $1250; Ron Ludford nnn-nnn-nnnn or xxxx@xxxx.xxx (Auburn CA)

Fairbanks Morse 1-1/2 hp Z headless crank & flywheels $50 obo; Tony McNeal nnn-nnn-nnnn or xxxx@xxxx.xxx (Amboy WA)

Fairbanks Morse Eclipse #1 vertical 1-1/2 hp hit & miss. New paint & cart, $700; Dale Somers nnn-nnn-nnnn (Medford OR)

Foos JR. Nice! New paint, on skids, ran spring of 2014, $1200. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Frisco Standard Gas engine, 5 hp, built in San Francisco circa 1915. This engine is in excellent original and running condition. It still shows original paint and patina and is totally complete with original parts. I found this engine when it was still in the fishing boat 20+ years ago. It was used on the Columbia River in fresh water. You can view this engine being started and running at http://youtu.be/obbBTQjtCQw $6500; Bill Prine nnn-nnn-nnnn or xxxx@xxxx.xxx (Amity OR)

GMC 3-71, runs good, no leaks, complete starter, flywheel and clutch, $1000; Larry Manley nnn-nnn-nnnn (Dorris CA)

Gray 1-1/2 hp, G. Raised Letters on one side of water hopper. Gray Motor Co, Detroit. Good paint. On skids. Had running spring of 2014, $800. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Hercules 5 hp, E. Ran good in spring of 2014. Has good compression. No cracks that I can see, one weld on the crank guard. No Cart. I can email photos, $850. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

IHC McCormick Deering LB 1-1/2 to 2-1/2 hp engine. It was built in 1948, sn LBA 132177. It is complete, turns over, has belt pulley and new cast iron hopper cover. It was running, but has a cracked spark plug (including a new spark plug, along with a manual, so it should be easy to get it running again). Engine weighs around 200 lb, so local pickup is preferred, but we might be able to deliver depending on location, $350 obo; Dan nnn-nnn-nnnn for details or photos (Tigard OR)

McCormick Deering 1-1/2 hp crank and flywheels, $50 obo. Bare block on nice skids, $75 obo; Tony McNeal nnn-nnn-nnnn or xxxx@xxxx.xxx (Amboy WA)

McCormick Deering 1-1/2 hp, 500 rpm, sn W1840, Wico mag, $750; Don nnn-nnn-nnnn (Newberg OR)

McCormick Deering 2 hp engine. Loose, needs a coil to run, $400 obo; Chris nnn-nnn-nnnn (Camano Island WA)

Olds 1-1/2 hp. Runs good. Reproduction mixer, but looks original. On skids, $3500. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Root and VanDervoort, 4 hp, 400 rpm, 1913, made for John Deere Plow Co,. in good running condition with 1,000 lb trailer. $2,500 for engine and trailer; Ivan Millich nnn-nnn-nnnn (Campbell CA)

Sandwich 1-1/2 hp. Webster mag. Ran good when it was put on the shelf a few years ago. On skids, $800. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Stickney 7hp engine, made in 1913, older restoration. Runs good. This engine has the correct fuel pump and rare clutch pulley assembly. It is sitting on homemade skids. I have a forklift to help load it. No trades please, $13,250; Terry Christner nnn-nnn-nnnn (Molalla OR)

Stover 1 hp V, comes with a shop built igniter trip. On skids, $850. Can be picked up in Tacoma, WA or will ship via Fastenal; Jim Beeler 253 531-5106 lv msg, or xxxx@xxxx.xxx (Tacoma WA)

Vaughn drag saw, with blade. Turns over, should run. Best offer takes it; Chris nnn-nnn-nnnn (Camano Island WA)

Waterloo Boy 4.5 hp complete engine on iron-wheel wagon. Webster mag rebuilt. Nice running engine. She's in her farm attire (old iron patina). Photos available, $1650; Ron Ludford nnn-nnn-nnnn or xxxx@xxxx.xxx (Auburn CA)