1915 Metz model 22 roadster, all original. Barn find. Chain drive. Gas head lights. Runs good, $10,000 cash firm. Call for more info; David Traver nnn-nnn-nnnn (Placerville CA)
1921 Ford Model T delivery truck. Back is covered with open sides, $9000; Hubert Bierly nnn-nnn-nnnn (Bend OR)
1923-25 Dodge 4cyl stuck engine w/trans, starter, gen, Dodge carb, manifolds, fan, air cleaner $100; Roland Bleitz nnn-nnn-nnnn (Grants Pass OR)
1944 Chevrolet 2-ton truck, very original, minor rust, $1500; Irvin Baker nnn-nnn-nnnn (Ripon CA)
1946 Chevrolet project street/driver. Cab, hoods, fenders, bright grille setting on 1983 Chev S-10 extended cab chassis. Titles for both. Various engines available $1,000; Russ Shorten nnn-nnn-nnnn or nnn-nnn-nnnn eves (Dayton WA)
1948 Chevy flatbed dump, 2 ton, pto twin hoist, wiring updated, all gauges work , 4+2 spd. currently has a 270 (6), have 235 core. New seat cover. Picture available. Nice truck, $1,000; William Ebrecht nnn-nnn-nnnn or xxxx@xxxx.xxx (Spokane Valley WA)
1949 Studebaker 1-1/2 ton Model 2R16 with 12’ St. Anthony flatbed. Commander engine with 4 speed transmission. Solid Eastern Washington truck. Good for total restoration, all complete. 7.50x20 tires, $1,250 firm; Russ Shorten nnn-nnn-nnnn or nnn-nnn-nnnn eves (Dayton WA)
1951 Chevrolet 2 Ton flatbed truck. This “workhorse” was a Propane delivery truck till 1969 when the tank was removed and the truck sold to present owners who built on the flat bed. The odometer reads 10,715 miles and the 6 cylinder 235 engine was completely rebuilt from the crankshaft up with satellite exhaust valves 4,000 miles ago. Four-speed transmission with power take-off, 2 speed rear axle, all new brake cylinders, all new window glass, solid body, good rubber with spare wheel, 6 volt system, directional signals, trailer wiring, rebuilt radiator, front mounted pipe rack for carrying long items, various extra parts and the old propane carburetor hook up and saddle tank. Last driven Sept. 2013 when battery removed and gas and water drained, always stored in the barn. Has current non-op license. Lots of life left! $2,500 firm; Clifford Curtice nnn-nnn-nnnn (Lotus CA)
1956 Buick Century 4-door hardtop. 55000 original miles, new paint, red & black, tires, radiator, heater core, drive anywhere; Don Eckelberry nnn-nnn-nnnn or nnn-nnn-nnnn (Noxon MT)
1956 Chevrolet parts leftover from restoration project. Complete set of stainless steel trim for 4 door hardtop. Have original 265 engine and transmission. Also have a good Chev 400 short block. Everything for $750; Ed Bring nnn-nnn-nnnn (Molalla OR)
1956 Mack B42 gas engine, runs. Cab is in good cond. Tandem axel rear suspension needs rebuilt, truck needs restoration, $2000 obo; Randy Cooper nnn-nnn-nnnn or xxxx@xxxx.xxx (Republic WA)
1962 International R 200 single-axle tractor, 5+3 spd, 450 ngas twin chrome stacks, super straight body, dual side tanks, excellent bang board, shines up really nice. Running when parked. Comes with 32 foot drop deck flatbed trailer, 8 ft dry van box on nose of trailer. Haul your tractor or team in style, dry storage/shelter too. Pictures available. Must go together, $2500; William Ebrecht nnn-nnn-nnnn or xxxx@xxxx.xxx (Spokane Valley WA)
1963 GMC V6, 4+2 gears with boom; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)
1965 Crown Coach, original 220 hp, mid-engine Cummins diesel, manual trans, single axel, low miles. Mechanically sound, aluminum body. Interior wiring/lighting full length generator compartment underneath (no generator). Endless possibilities for conversions: RV, haul antiques,
bikes, ATV, etc. The rear section could be cut out under the existing hinged rear window and a ramp/hoist installed. Has flat floor front to rear; Dennis nnn-nnn-nnnn (Carmichael CA)
1966 Ford F703 has 5th wheel set up equipped with air brakes; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)
1966 IHC 190 Cabover. Excellent cab, glass is good except crack in wind shield. 6 cyl. gas runs good has crack in exhaust manifold. long frame. Truck would make good car /tractor hauler 5spd with 2 spd. Rear, 10.00-20 tires, Budd wheels, $1800 obo; Randy Cooper nnn-nnn-nnnn or xxxx@xxxx.xxx (Republic WA)
1968 G.T.O rear bumper good condition with license plate frame. The chrome is fair to good, $200; Mike Cristler nnn-nnn-nnnn or xxxx@xxxx.xxx (Zamora CA)
1969 Chevrolet CST 350 cab & chassis, factory cab lights, no engine or trans, $1000; Eric Bygness nnn-nnn-nnnn (John Day OR)
1973 International 1610 V8, 5+2, with 20 ft van high box; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)
1979 Ford with 18 ft van box, V8, 5 speed; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)
1981 Isuzu diesel pickup, 2 wheel drive, 5 speed, 30 mpg. Runs good, tires are good. No rust, $2300; Robert C Pierce nnn-nnn-nnnn (Omak WA)
Federal truck radiator. The bottom tank is rusted out. The rest is in very good condition. There are no dings in the core. It looks to me that it will fit a 1915-1918 It is very nice. $600; Mike Cristler nnn-nnn-nnnn or xxxx@xxxx.xxx (Zamora CA)
Ford Model T parts for sale; Dave Gallant nnn-nnn-nnnn (Boring OR)
Graham Bros. truck parts, mostly 1927, many truck parts 3 and 4 of some parts, can load if needed, will need to know before hand to have the forklift here, $2500; Irvin Baker nnn-nnn-nnnn (Ripon CA)
John Deere Gator AMT 600. 5x4 has hydraulic dump bed, excellent tires, new battery, $2250; Don Chappell nnn-nnn-nnnn (St Helens OR)
Peterbilt truck grill, 35-3/4” x 41-3/4” stainless steel, minor damage, spot repairable, otherwise good, $500; Irvin Baker nnn-nnn-nnnn (Ripon CA)
Samson trucks: two Samson trucks, one is mostly complete including wooden C cab, the other is an engine, radiator, transmission, chassis, and axles. Both trucks will need a full restoration, they are both somewhat apart. Both trucks are the smaller 3/4 ton model. One truck could be built with the two, $4250; Mr Kim Kestler nnn-nnn-nnnn (Reno NV)
Vehicle engines: rebuildable Corvair; rebuildable 1953 Chev 235. Rebuildable 1966 Chev 283, ran good when removed. Rebuilt 318 Dodge, ready to install; Robert McLaughlin nnn-nnn-nnnn (Benton City WA)
Vehicle parts: 1947-56 Chev and GMC fenders, hoods. 1941-‘46 Chev cab, hoods, fenders. 1959 GMC truck Series 350 bright metal grille and bumper, hood, fenders. 1954 GMC 450 hood, fenders. 1973-‘80 Chev/GMC doors, hood, fenders, windshield. Call with your needs; Russ Shorten nnn-nnn-nnnn or nnn-nnn-nnnn eves (Dayton WA)
Wanted: Hemi motors; Charlie Parish nnn-nnn-nnnn (Merced CA)
Wanted: Looking for tires for vintage Dodge and Chevy Coupe size 600x16 in good shape or better yet would take radials equivalent to this size; Joe Giordano nnn-nnn-nnnn (Port Orchard WA)
Wanted: Peterbilt bubble nose truck. Looking for a Peterbilt 280/350 bubble nose cab over truck; Mr. Kim Kestler nnn-nnn-nnnn (Reno NV)
Wanted: Pontiac autos; Charlie Parish nnn-nnn-nnnn (Merced CA)
Wanted: two axle dump trailer to haul behind pickup, even if needs work, approximately 7x12 foot but will consider otherwise, willing to travel in Washington/Oregon; Joe Giordano nnn-nnn-nnnn (Port Orchard WA)
Waukesha mod. B, BU4, T or TU4 4cyl motor 1914-1928 era, 3.5"-3.75" bore wanted; Kevin nnn-nnn-nnnn or od4473@yahoocom (Newport Beach CA)