American MARC 1 cyl air-cooled diesel, new, never used, made in Englewood CA, early ‘50’s or ‘60’s, $600; Buck Evans nnn-nnn-nnnn (Greenville IL)
American MARC air-cooled 1 cylinder diesel, new, never used, American made, $600; Buck Evans nnn-nnn-nnnn (Greenville IL)
Atlas Imperial 12 hp 2 cylinder gas engine. This is a rare Oakland, CA built marine engine from around 1918. This engine is complete including igniters, Manzel oiler, whistle air pump and water pump. It is stuck but mechanically in excellent shape with lots of oil in crankcase. The cylinders are starting to crack from salt water cooling but the heads are still good. This engine needs to be disassembled and restored while the cylinders can be saved, I have too many other projects at this time. This is your opportunity to own a rare California engine that you will not see at any shows, $3500 obo; Bill Prine nnn-nnn-nnnn or email for photos at xxxx@xxxx.xxx (Amity OR)
Benz 5hp sideshaft engine, this is a Czech made engine on factory cart with cooling tank. This is a larger size than you usually see and has a wheel brake for the cart. The smaller size engines never have cart brakes. Engine has 32" flywheels and uses an inertial type governor that is interesting to watch. Lots of original paint still on engine and hard to find a Benz of this size and quality. Haven't run it in the last 6 or 8 years, but it was shown at the Brooks Steam Up. $10k; George Best nnn-nnn-nnnn (Beaverton OR)
Bullseye 7-1/2 hp side shaft gas engine. This is a completely original Bullseye right down to the gas tank and wood skids. This is a beautiful running hit n miss engine with lots of original paint and pin striping. It has the rare Accurate understrike magneto with igniter mounted on the head. It has never been restored, $8500 obo; Bill Prine nnn-nnn-nnnn. Email for photos at xxxx@xxxx.xxx (Amity OR)
Delco Light Plant #850, 24v., $150; Steve nnn-nnn-nnnn (Stockton CA)
Engines for sale: Cuyuna engines: five new 40 hp engines manufactured for snow mobile units. Can be adapted for other uses, $650 each, or make offer on all five. For info call Ed nnn-nnn-nnnn (Sheridan OR)
Fairbanks Morse 1-1/2-2 hp D engine, with pulley. It's mounted on a rubber-tired cart. This is a cute engine, $275; Ken nnn-nnn-nnnn (Clarksburg CA)
Fairbanks Morse 3 hp. This engine stands out. Has a rotary J mag, and is mounted on new cart. The splash guard has a hand painted steam engine on it. $675; Ken nnn-nnn-nnnn (Clarksburg CA)
Fuller and Johnson 2-1/2 hp, older restoration on nice cart, $450. Email for photos. Free delivery to Turlock or Tulare; John Boehm nnn-nnn-nnnn or xxxx@xxxx.xxx (Woodland CA)
Fuller Johnson 3-1/2 hp project engine, everything was bead blasted cleaned and re-assembly started. 85% together, with a hot Wico EK magneto, $750. Pictures on request; Craig Mathews nnn-nnn-nnnn or xxxx@xxxx.xxx (Northridge CA)
Galloway 2-1/4 hp, water-cooled, runs, $1500; Rob Anderson nnn-nnn-nnnn after 5PM or xxxx@xxxx.xxx (Fresno CA)
Harris 55 hp 4-cylinder Engine. Has not been run in a while, but it draws a lot of attention at engine shows! Skid-mounted with original clutch and flat belt pulley. Has some small external water-jacket cracks. I have the original galvanized air cleaner, fuel pump canister, and clutch lever. This was built in Stockton, California and used on a combine. Asking $5000. Will consider best offer; Richard nnn-nnn-nnnn or xxxx@xxxx.xxx (Geyserville CA)
Hercules 3 hp engine with Los Angeles jobber plate, came from old Kernville, $650; Don Decker nnn-nnn-nnnn or xxxx@xxxx.xxx (Ridgecrest CA)
Hercules Economy 5 hp with Elkhart Mag setup. New fuel tank, nice barn fresh engine on a really nice shop built heavy cart. Runs well, $1800. Pictures on request; Craig Mathews nnn-nnn-nnnn or xxxx@xxxx.xxx (Northridge CA)
Lorenz 4-6hp sideshaft engine. This is a Czech made engine that I've had for years. It is very unusual in that it came from the factory with green paint and red pin striping as part of a special order. This is a larger size Lorenz than you usually see in this country and has heavy 32" flywheels. Comes on factory cart with cooling tower and pump. I haven't run this engine in 10 years, but it is complete and should run with a little fresh gas and the flick mag limbered up. $10k; George Best nnn-nnn-nnnn (Beaverton OR)
Moline Plow 6-1/2 hp, sn 51910, restored except igniter & mag need mounted, $1200; Kathy Repp nnn-nnn-nnnn or xxxx@xxxx.xxx (Snohomish WA)
Monarch (Nelson Brothers) 7 hp, sn 1378, $1750, email for pictures and details; Kathy Repp nnn-nnn-nnnn or xxxx@xxxx.xxx (Snohomish WA)
Nelson Bros 1-3/4 hp Little Jumbo T, on cart, very clean and nice running engine, $1200 obo; Don Decker nnn-nnn-nnnn or xxxx@xxxx.xxx (Ridgecrest CA)
Novo 4 hp Type S. Partially assembled, restoration started. One flywheel has a hub repair, but it was done well, $850; Craig Mathews nnn-nnn-nnnn or xxxx@xxxx.xxx (Northridge CA)
Novo single cylinder, 6 hp, rare throttle governed kerosene engine; Don Decker nnn-nnn-nnnn or xxxx@xxxx.xxx (Ridgecrest CA)
Propane set-up for 2 cylinder Wisconsin, $60; Buck Evans nnn-nnn-nnnn (Greenville IL)
Sears & Roebuck 1.5 hp model 500 205515. Includes a water pump. Motor runs but pump needs de-rusting; Lauson engine 1.75 hp; engine is clean and runs. $20 each; John Lindner nnn-nnn-nnnn or xxxx@xxxx.xxx (Pacifica CA)
Standard 5 hp Hoist Engine. Vertical side-shaft engine with breaker point ignition, and winch drum on cast base. Built in San Francisco. I have gotten this to fire, but I have never run it. It's very cool, and very rare, and makes a unique display. Looks like an old restoration. Has some very repairable external cracks in the water jacket. Asking $6000. Will consider best offer; Richard nnn-nnn-nnnn or xxxx@xxxx.xxx (Geyserville CA)
Stover CT 2. Hot Wico mag, just tuned up. The engine is neat and clean, on skids, $425 complete or without the mag, $250; Ken nnn-nnn-nnnn (Clarksburg CA)